The board dividing machine usually refers to the PCB board dividing machine, namely the circuit board dividing machine. The divider is widely used in electronic products manufacturing industry. Due to the strong stress produced by the traditional manual folding method, which has a serious impact on the product quality, the artificial folding plate has been basically replaced by the machine.
Confirm the power supply voltage AC220 V before starting
Turn on the power switch on
There are five stroke settings: 0, 100, 200, 300 and 400, and the appropriate travel is selected according to the plate to be divided
Adjust the height of the cutter according to the thickness of the plate. According to the speed selection key: super fast, fast, medium speed, slow speed to select the running speed of the equipment
Adjust the height of the platform to ensure that the PCBA board is placed horizontally
The edge groove of PCBA should be stuck in the position of the lower cutter of the dividing machine. Hold the PCBA with both hands and step on the pedal gently with your foot until the cutter reaches the set distance and stops automatically
注意事项：matters needing attention:
This equipment is only used for dividing board. Operators should wear anti-static gloves according to company regulations
Attention should be paid to hand ornaments, hair and loose clothes during operation, so as to avoid safety problems.
When cutting the board, you must select two positions before stepping on the pedal switch, otherwise the cutter wheel will not run
In case of any abnormality, press down the emergency switch and release the pedal switch to prevent accidents